Selamat datang ... Welcome ...

Ku jadikan blog ini tempat untuk menyimpan semua yang telah aku ketahui, yang masih dapat aku ingat dan yang baru aku mengetahuinya, agar disaat lupa dapat aku membacanya lagi.

I made this blog a place to save all that I already knew, that I can still remember and new ones I know, so when I forget may read it again.

Wednesday, May 20, 2009

Error Code for Canon MP 145, MP 150, MP 160 Printers

Function listed in the table below (Each time the Stop/Reset button is pressed, the LED lights alternately in orange and green, starting with orange).
The number of the Reset button pressing, LED Function Remarks
0 time Green Power off
1 time Orange Service pattern print
2 times Green EEPROM print
3 times Orange EEPROM reset
4 times Green Waste ink counter reset
5 Unplug cable power. (for MP145 / MP150)
6 Turn Off Power. (for MP160)

Error Code :
E2-2 = No paper (ASF)
E3-3 = Paper jam
E4 = No ink
E5-5 = The ink cartridges are not installed or a non-supported inkcartridge is installed, or the ink cartridges are not installed properly
E8 = Waste ink absorber full, or platen waste ink absorber full
E9 = The connected digital camera / video camera does not support Camera Direct Printing
E14 = The Ink cartridges whose destination are wrong
E15 = Ink cartridge is not installed E16 - Ink remaining is unknown
E16 -E19 = Failed to scan head alignment sheet
E22 = Carriage error
E23 = Paper feed error
E24 = Purge unit error
E25 = ASF(cam) sensor error
E26 = Internal temperature rise error
E27 = Waste ink absorber full or platen waste ink absorber full
E28 = Ink cartridge temperature rise error -
E29 = EEPROM error
E33 = Paper feed position error
E35 15 = USB Host VBUD overcurrent error - USB
E37 17 = Abnormal motor driver error
E40 20 = Other hardware error
E42 22 = Scanner error

This is how to resolve error code E27 for canon MP series

  1. With the printer powered off but connected to a power source, press the Power button while pressing and holding the Stop/ Reset button.
  2. When the Power is lit, press the Stop/Reset button two times while pressing and holding the Power button.
  3. When releasing the Power button and the Stop / Reset button (regardless of order), the printer will move into a service mode. (Waiting for menu selection)
  4. When the on/off lights in green, press the Stop/Reset button the specified number of time(s) according to the function listed in the table below.(Each time the Stop/Reset button is pressed, the LED lights alternately in orange and green, starting with orange.)note: press 4 times for waste ink counter reset.

PS: Call the expert to avoid your computer software or hardware damage.
Posted by